Mb

Fiber-reinforced cement based stucco powder
For indoor or outdoor use
FEATURES:

Mb RASANTE is a fiber-reinforced cement mortar, composed of cement, quartz, light aggregates and specific additives, having a particle size of less than 0.6 mm, which make the product highly filling and resistant to shrinking, providing high capacity of adhesion and workabilit

INSTRUCTIONS FOR USE:
Thoroughly clean the surface to be treated, completely removing any residues of old paints and plastering not sufficiently anchored. Moisten the area concerned to promote a perfect adhesion. Mix by hand and/or with a mechanical stirrer at low speed in a container, Mb RASANTE with about 28% of water to form a smooth mix workable for about 45 minutes. The recommended thickness for each layer is approximately 1 cm; for filling it is also possible to reach 5 cm. Apply with a spatula and/or trowel, depending on the requirements. Setting times are variable depending on the thickness and the climate conditions. Mb RASANTE should be used in its original state, without adding any extraneous materials.

WHERE IT IS USED:
The product thus obtained is ideal for the restoration of items in concrete, irregular plastering (beams, pillars). Great for smoothing prefabricated panels, façades and external supports. Ideal for restoring decorative items (outdoor and indoor): balconies, edges of frames and stairs.

CAUTION: DO NOT USE Mb RASANTE AS MORTAR FOR STRUCTURAL RESTORATIONS.

PRACTICAL TIPS:
Firmly close the package after a partial use. Store in a fresh, dry environment. It is recommended to wait a few days before painting, due to the partial evaporation of the cement.

USAGE NOTES:
Paints, coatings, wallpapers, etc., should be applied only after the complete drying and seasoning of the product. The preparation of Mb RASANTE with electrical tools can alter the properties of the stucco, therefore it is recommended to prepare small quantities, using the mechanical stirrer at a low number of revolutions (<800 revolutions per minute).

Highly resistant to weathering.
- Highly breathable.
- High thixotropic power.
- Resistant to blows and scratches.
- Reinforced with synthetic fibres that do not alter over time.
- Highly filling and shrink-resistant primer.
- High capacity of adherence even on old, textured plastering.

PROCESSING TIME:
45 minutes.
 
APPLICATION TEMPERATURE:
5°C to 40°C
         
DRYING AT 20 °C:
2 to 4 hours.
 
FOR SMOOTHING:
1 cm each layer.
FOR FILLING:
up to 5 cm.
         
YIELD:
1 m²/kg (thickness of approximately 1 mm).
 
VARNISHABLE:
once drying is complete.
         
FOR INDOOR USE.
 
RECOMMENDED TOOLS:
spatula and trowel.
       
FOR OUTDOOR USE.
 
 
 
TECHNICAL DATA SHEET
 
SAFETY DATA SHEET
 
PERFORMANCE DECLARATION